Morrisville, NC

York 14 seer air conditioner and 80% gas furnace

Found back system compressor bad. Checked front system and found system r22 coil leaking. Found contactor assembly pitted. Found single start assembly reading below manufacture specs. System is over 30 years old. Comfort advisor will send price for replacement and compressor

Changed filter

York 14 seer air conditioner and 95% gas furnace for whole house.

Found system combusting system bad making loud noise. Customer needs to replace combustion system. Also found dual start assembly reading below manufacture specs. Told customer every system starts the compressor and outdoor fan are both getting damaged. Customer has a leak in system. Gave customer options to make repairs. Customer is talking to comfort advisor about replacement

Preformed full system tune up. Checked heater kit 20amps. Checked blower amps 5.1. Checked refrigerant pressures r410 425/125. Checked compressor amps 10.1. Checked outdoor fan amps 1.3. Single start assembly 10/10. Three phase system. Found no surge protection

The system now operates in cooling, and heat. There was a short in the thermostat wire.

The flame sensor, and single start assembly replaced on said unit. The heat was cycled on, and is operating normally.

York 14 seer air conditioning system and 80% gas furnace

Found system low on r410a charge and off on low pressure safety switch. Customer has a leak in indoor coil. Also found weak flame safety system. Found indoor single starts assembly reading below manufacture specs. Told customer every time system starts the blower motor is getting damaged. Also found duct system dirty. Gave customer options to make repairs. Customer said he will see if he can get a approval then follow up with us

Here a two system furnace fall maintenance performed, and one issue to report. The upstairs system has a single start assembly that has to be replaced. Also better quality products will be recommended for cleaner air inside the home. All amp draws are within tolerance on both systems, and the upstairs system amp draws are as follows. Induce draft fan 1.25 indoor fan motor 2.53 flame sensor 5.3 mili volts igniter 18.8 ohms the single start assembly was reading 1.5uf rated for 5uf. Heat rise at 70* within manufacturing specifications. The downstairs furnace induce draft fan 1.23 amps indoor fan motor 3.23 flame sensor 4.5 mili volts igniter 18.2 ohms both systems are running in heat as of now.

Here during the inspection of the down unit. The filters were found restricted, and this caused the system to freeze due to a restriction of airflow. The filters are being ordered, and a estimate has been given for a future repair of the contactor on the front unit near kitchen.

Performed system maintenance on both 2014 Carrier AC/Furnaces. Tested all system components along with heating and cooling operations. Systems are operating properly at this time. Did find both systems without adequate water protection. Systems only have secondary pan switches. Recommend installing auxiliary drain water safety switches which would not allow water to enter drain pan at all. Also recommend replacing air purification bulbs.

Arrived to perform heating maintenance. System is 2014 Trane AC/Furnace which services the whole home. System has 2 zone Honeywell zoning system which allows independent control of the first and second floors of the home. Tested all heating components along with heating operation. Also cleaned flame sensor and burner area of the system. System is operating properly at this time. Did find older style air movement control for the first floor which could potentially fail. The other 2 air movement controls have been replaced. Found the blower motor covered in dust as well which is adversely affecting air quality in the home. Provided all findings to homeowner and discussed solutions to today’s findings. Homeowner will review options and decide at a later time. Homeowner did renew maintenance membership at this time. Thank you for choosing Heroes Heating and Cooling!

York 15 seer air conditioning system and 80% furnace for whole house

During service call, tech found burnt out compressor and multiple other parts on unit nearing failure. As unit is 22 years old and out warranty, tech recommends unit upgrade. Unit is not functioning at this time.

Tech arrived for duct cleaning estimate of first floor. Estimate will be 495+tax.

Trailer unit/do not work on these

Found system ceiling saver switches opened. Bypassed switch and system is now working.

Arrived due to homeowners concerns of airflow issues. System is 2014 ICP AC/Furnace which services the whole home. System has 3 zone no zoning system which allows independent control of each floor of the home. Today’s diagnostic revealed 3 failed air movement controls for the zoning system. Provided information to the homeowner and discussed repair options. Homeowner elected not to proceed at this time.